Arduino based Snake Robot Controlled using Android Application

Download Project Document/Synopsis

Arduino based Snake Robot Controlled using Android Application
Tested

Tested

The snake contains twelve segments motivated by servo motors and joined with metal brackets. The servos are controlled by an Arduino Mega and powered by a 7.4-volt battery pack. The snake can be controlled by an android app using Bluetooth. The snake is also capable of autonomous movement. Such a robot can be constructed with many different types of servos and brackets. Each of the 12 segments consists of a servo motor, a C-bracket, a side bracket, a wire clip and a set of Lego wheels. Two screw holes is to be drilled into the Lego wheel axle to permit it to be connected to the C-bracket. After all, 12 segments are connected, head and tail sections need to be added in order to accommodate the Arduino and batteries. To make them a side bracket and two long C-brackets connected. The Arduino and therefore the 5AA battery holder are used that powers it into the tail section of the snake. The servos are powered by a separate supply, the 7.4-volt battery pack, goes into the head of the snake. On the receiver, the bottom pin is connected to the Arduino ground. The voltage pin is connected to a 5-volt pin from the Arduino.

nevonproject electronics kits
nevonproject electronics kits


  • Hardware Specifications
  • Dual shaft Servo
  • WIFI camera
  • Analog distance sensor
  • Arduino Mega2560
  • Arduino Mega servo Shield
  • Bluetooth Module
  • Capacitors
  • Cables and Connectors

Block Diagram

Arduino based Snake Robot Controlled using Android Application

Leave a Comment

Your email address will not be published.